Started out funny, got kind of hapless, but at least one painter became sucessful. Actually John's dry sense of humor was present throughout the book, but just not as much as in the beginning. I am just about to start a painting and minor maintenance business and I must say, this book does not make me want to go rushing into it enthusiastically, but I am going to do it anyway as my business model is sole proprietorship and not a bunch of painting employees working together in one company. Lots of great painting tips in the book, but nothing compared to the wealth of information on John's website.
Sand the trim with a fine-grit sanding sponge. Sponges get into crevices where sandpaper can’t go and let you apply even pressure. Then apply the ﬁrst coat of paint, let it dry at least 24 hours, lightly sand it again for a completely smooth surface, and apply the second coat. After each sanding, vacuum the trim, then wipe it down with a tack cloth to remove the dust.
"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.
You are right on with this - why do people leave switch plates on when it's just so easy to take them off? Another thing that happened to us - we had the popcorn ceiling taken off and the ceiling painted white. When the job was done and I later went to change out all the fixtures/fans, they had left every fixture in place, so there was a large patch of popcorn and unpainted ceiling left behind - it just didn't dawn on me to specify that they take those down before scraping and painting. It was kind of a mess.
House Painting Co